Cradlepoint IBR1100 User Manual page 95

User Manual / IBR1100/IBR1150
Interval or Stationary Time Interval if desired. (Specifing a value of 0 seconds disables Stationary Event
Threshold reporting.)
• Stationary Distance Threshold (meters) - The distance (meters) between two consecutive GPS fixes to
discount, treating the unit as stationary to be used in conjunction with stationary time reporting. Note:
Setting the Stationary Distance Threshold to
values near the low end increases the possibility of
incorrectly detecting the vehicle as moving due to GPS
"jitter." (Specified in meters between 20 - 65535.)
• Distance Interval (meters) - The distance (meters)
over ground between two GPS fixes, which when met
will trigger reporting of GPS sentence(s). Note: Setting
the Distance Interval to values near the lower end
increases the possibility of incorrectly issuing a report
due to GPS "jitter." (Specifying a value of 0 meters
disables distance interval reporting.)
Send to Server(s)
• Enable this client - Enables periodic reporting of GPS
sentences to a remote server. The router will buffer
GPS sentences if errors are encountered or if the
Internet connection goes down, and send the buffered
sentences when the connection is restored.
• Client name - Your client's name should include only
Aa-Zz, numerals, and '_'.
• Server - Remote server hostname or IP.
• Port - Remote server port.
• Use UDP - Using UDP instead of TCP reduces the load
on the router and may save bandwidth. However,
UDP does not provide any guarantee for delivery. The
router will typically assume sentences have been
received by the remote UDP server and will not buffer
those sentences.
• Number of stored sentences - Set the maximum
number of sentences that can be stored when the
router does not have a connection to a server.
• Specify Time Interval - Restricts the GPS sentence
reporting to a remote server to a specific time
interval.
• Start Time - Reporting start time.
• End Time - Reporting end time.
NOTE: Language Settings and Reporting Intervals options are identical to those for Send to Client(s).
Send to Serial
• Enable this client - Enables periodic reporting of GPS sentences on the serial port. The serial port settings
can be adjusted at SYSTEM > Serial Redirector under Serial Adapter Configuration.
• Client name - Your client's name should include only Aa-Zz, numerals, and '_'.
• Port - Remote server port.
NOTE: Language Settings and Reporting Intervals options are identical to those for Send to Client(s).
©2016 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com
7/15/16
95