IMPOR TANT NOTICE This manual has been provided for the use of authorized Yamaha Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifically Yamaha Products, are already known and under- stood by the users, and have therefore not been restated.
EMX3000 3 7 63 1515 0 SPECIFICATIONS General specifications STEREO: 300 W+300 W/4Ω @0.5% THD at 1 kHz Maximum output power 215 W+215 W/8Ω @0.5% THD at 1 kHz BRIDGE: 600 W/8Ω @0.5% THD at 1 kHz 20 Hz~20 kHz +1 dB, –3 dB @1 W output into 8Ω...
Page 4
EMX3000 3 7 63 1515 0 Input specifications Input level Gain Actual load For use with Input terminals Connectors on mixer trim impedance nominal Max. before clip Sensitivity –60 dB (775 µV) –40 dB (7.75 mV) MIC INPUT (1–8) kΩ...
Page 7
EMX3000 3 7 63 1515 0 PANEL LAYOUT Control Panel Channel Control Section GAIN GAIN GAIN control PEAK PEAK HIGH HIGH A/B switch (Channels 9/10~11/12 only) PEAK indicator Equalizer controls (HIGH, MID, LOW) Monitor 1/2 controls (MONI 1/2) Effect control (EFFECT)
Page 8
EMX3000 3 7 63 1515 0 Master Control Section MONI 1 (monitor 1) fader MONI 2 (monitor 2) fader EFFECT fader ST 1 (stereo 1) fader MONO (monaural) fader AFL (after fader listen) MONI 1 MONI 2 EFFECT ST 1...
Page 9
EMX3000 3 7 63 1515 0 Power amp Section LIMITER indicator LIMITER LEVEL controls LEVEL Power amp select switch BRIDGE ST1 L ST1 R MONI 1 MONO MONO (BRIDGE) POWER AMP Other indicators and controls Peak level indicator POWER indicator...
Page 10
EMX3000 3 7 63 1515 0 Rear panel SPEAKERS SPEAKERS (speaker output) jacks MONO MONI 1 POWER switch AC inlet BRIDGE AC IN POWER CIRCUIT BOARD LAYOUT PWR2 PWR2 L 13942296513 PWR1 MAIN INPUT OUTPUT ST 1 11 L...
Page 11
EMX3000 3 7 63 1515 0 WIRING 12pin MAIN CNM01 13pin CNM04 PWR1 CN101 4pin 13pin CN103 2pin CN104 CN102 3pin 3pin CN101 6pin 12pin CN105 CN102 CN106 3pin PWR2 PWR2 L 13942296513 DC fan 3pin CN301 Power transformer...
EMX3000 3 7 63 1515 0 DISASSEMBLY PROCEDURE Panel Assembly and Bottom Assembly (Manhour requirement: 5 min.) 1-1. After removing the six (6) screws marked [90] and six (6) screws marked [100], lift the rear side of the assembly and remove it from claws on the front.
Page 15
EMX3000 3 7 63 1515 0 [P50] [P50] [P70] [P70] [P70] [P50] [P40] [P40] MAIN [P40] [P40] [P70] [P70] [P40] [P70] [P40] [P70] [P40]: Flat Head Tapping Screw-B 3.0 X 25 MFZN2BL (VV095300) [P50]: Bonding Screw-B 3.0 X 8 MFZN2BL (VN413300) [P70]: Bind Head Tapping Screw-B 3.0 X 6 MFZN2BL (EP600230)
Page 16
EMX3000 3 7 63 1515 0 Power transformer (Manhour requirement: 10 min.) 7-1. Remove the panel assembly and the bottom assembly. (See Procedure 1.) 7-2. Remove the hexagonal bolt. The power transformer can then be removed. (Fig. 3) (See Fig.3 for drawing direction of wiring assembly.)
EMX3000 3 7 63 1515 0 LSI PIN DESCRIPTION ZFX-2 (XY297A00) CPU DSP: IC105 NAME FUNCTION NAME FUNCTION AXLR2 Audio Data Transmitt Unit 2/3 Left and Right Channel Frame Frequency Signal Audio Data Receive Unit 1 Data Input External Memory and I/O Data Bus...
Page 18
EMX3000 3 7 63 1515 0 PCM3001E/2K (X0053A00) ADA DSP: IC104 NAME FUNCTION NAME FUNCTION VINL ADC Analog Input, Lch VOUTL DAC Analog Output, Lch Vcc1 LRCIN ADC Analog Power Supply Sampling Clock Input (fs) AGND1 BCKIN ADC Analog GND...
EMX3000 3 7 63 1515 0 CIRCUIT BOARDS MAIN Circuit Board INPUT LINE LINE LINE LINE LINE LINE LINE LINE INSERT INSERT INSERT INSERT 9/10 11/12 GAIN GAIN GAIN GAIN GAIN GAIN GAIN GAIN GAIN GAIN GAIN GAIN GAIN...
Page 21
EMX3000 3 7 63 1515 0 OUTPUT FOOTSW CNM01: to PWR1-CN102 TAPE MONO L(MONO) MONI1 MONI2 EFFECT LINE R ST-SUB1 R ST-SUB2 C-R/PHONES 9/10 11/12 C-R/PHONES POWER PEAK TAPE IN ST TAPE IN ST TAPE IN ST MONI 1...
Page 22
EMX3000 3 7 63 1515 0 MAIN Circuit Board L 13942296513 u163 http://www.xiaoyu163.com...
Page 23
EMX3000 3 7 63 1515 0 L 13942296513 u163 Pattern side http://www.xiaoyu163.com...
Page 24
EMX3000 3 7 63 1515 0 DSP Circuit Board CN102: to PWR1-CN101 L 13942296513 CN101: to MAIN-CNM04 Component side u163 Pattern side 3NA-V698320 http://www.xiaoyu163.com...
Page 25
EMX3000 3 7 63 1515 0 PWR1 Circuit Board L 13942296513 CN103: to PWR2 2/3 W301RE W301WH W301BE W301BL CN105: to Transformer CN106: to PWR2 3/3 W302RE W302BL W302BE Component side u163 3NA-V698330 http://www.xiaoyu163.com...
Page 26
EMX3000 3 7 63 1515 0 PWR2 1/3 Circuit Board to Transformer POWER ON/OFF Component side AC IN to PWR1 to PWR1 to PWR1 to PWR1 PWR2 2/3 Circuit Board -CN103 4 -CN103 3 -CN103 2 -CN103 1 L 13942296513...
Page 27
EMX3000 3 7 63 1515 0 INSPECTIONS A. INSPECTION OF MIXER SECTION PREPARATIONS • Unless otherwise specified, the signal to be applied should be 1kHz, -70dBs sine wave and the signal source impedance should be 150 ohm. Also, the load resistance at each output terminal should be of the following values.
Page 28
EMX3000 3 7 63 1515 0 1-7 POWER AMP POWER AMP switch ST1L-ST1R POWER AMP (L/BRIDGE, R) level control Minimum 1-8 PHANTOM PHANTOM switch 1-9 Measuring equipment • The oscillator connected to the balanced type input terminal should be balanced output type with 150 ohm output impedance.
Page 29
EMX3000 3 7 63 1515 0 • In the state as described in 1 above, input the signal of the following level to MIC IN of CH1 and turn on each AFL switch. Then check that the output as described in [Table 2-5] is obtained at C-R/PHONES OUT (L, R).
Page 30
EMX3000 3 7 63 1515 0 DISTORTION FACTOR • In the state as described in 1, check that the distortion factor when +14dBs output is obtained at each output terminal is 0.1% or less (except for REC OUT and INSERT OUT).
Page 31
EMX3000 3 7 63 1515 0 B. INSPECTION OF POWER AMPLIFIER INSPECTION AT ST1L-ST1R PREPARATIONS • Input terminal: ST SUB IN 1 L/MONO • POWER AMP Switch : ST1L-ST1R • POWER AMP (L/BRIDGE, R) level control:MAX • Output terminal: SPEAKER L (1), SPEAKER R (1) •...
Page 32
EMX3000 3 7 63 1515 0 10 PROTECTION CIRCUIT • With a signal input to POWER AMP IN (L), clip the output waveform of the 10Hz signal and check that the protection circuit functions to prevent the relay from opening.
3 7 6 3 1 5 1 5 0 EMX3000 EMX3000 CIRCUIT DIAGRAM 1/9 ( MAIN 1/5 ) ( from P.C5-F6 ) MAIN NJM2068L-D OP AMP OP AMP OP AMP OP AMP OP AMP NJM2068L-D NJM2068L-D OP AMP OP AMP...
3 7 6 3 1 5 1 5 0 EMX3000 EMX3000 CIRCUIT DIAGRAM 2/9 ( MAIN 2/5 ) ( from P.C1-H6 ) NJM2068L-D OP AMP OP AMP OP AMP OP AMP OP AMP NJM2068L-D NJM2068L-D OP AMP OP AMP...
3 7 6 3 1 5 1 5 0 EMX3000 EMX3000 CIRCUIT DIAGRAM 3/9 ( MAIN 3/5 ) ( from P.C2-H6 ) OP AMP OP AMP OP AMP OP AMP OP AMP OP AMP OP AMP OP AMP 1 3 9 4 2 2 9 6 5 1 3...
http://www.xiaoyu163.com 3 7 63 1515 0 POWERED MIXER PARTS LIST CONTENTS OVERALL ASSEMBLY ..........2 ELECTRICAL PARTS ..........5 L 13942296513 Notes : DESTINATION ABBREVIATIONS A : Australian model M : South African model B : British model O : Chinese model C : Canadian model Q : South-east Asia model D : German model...