Table of Contents
Advertisement
Before Operating This Set
Safety Precaution
Please take safety precautions to prevent the unit form
falling over.
The unit may fall over during earthquakes, or if someone
stands on or shakes the TV.
Connecting the Plug to the Wall Outlet
How to Turn the Power On
Power Indicator
Power Switch
Notes:
• When in the Stand-by condition (Refer to page 13), it is also possible to turn the TV set on by pressing any of the
"Direct Programme Number Selection buttons" (0-9) or "Programme Number Up or Down buttons" on the TV set or
on the Remote Control.
• If the Wall Outlet is switched OFF or the Main Plug is unplugged, when the TV set is again turned ON (by either
connecting the Main Plug to the Wall Outlet or switching the Wall Outlet ON), it will have returned to the original state.
6
Fixing to a wall
Use a strong rope or a chain
to fasten the TV firmly to a
strong support such as a wall
or a pillar.
Note:
The On/Off switch on this model does not full disconnect the TV from the
mains supply.
Power OFF
Power ON
/ Securing the casters
To prevent the set from tipping forward, turn the two
casters on the front of the TV so they face forward, as
shown in the picture.
Power Indicator
No light: Power OFF condition
Note: Even when the Power Switch is "OFF", the TV set
will still consume a small amount of power.
Push the Power switch on Television to turn the set on.
Power Indicator
No light: Normal viewing condition
Red
: Stand by
Advertisement
Table of Contents
