Error Log Codes - Frymaster OCF30 Service & Parts Manual

1.12.4

Error Log Codes

Code ERROR MESSAGE
E03 ERROR TEMP PROBE FAILURE
E04 HI 2 BAD
E05 HOT HI 1
E06 HEATING FAILURE
E08 ERROR ATO BOARD
E17 ERROR ATO PROBE
E20 INVALID CODE LOCATION
E21 FILTER PAPER PROCEDURE ERROR
(Change Filter Paper)
E22 OIL IN PAN ERROR
E25 RECOVERY FAULT
E27 LOW TEMP ALARM
EXPLANATION
TEMP Probe reading out of range
High limit reading is out of range.
High limit temperature is past more than 410°F
(210°C), or in CE countries, 395°F (202°C)
A component has failed in the high limit circuit
such as controller, interface board, contactor or
open-high limit.
ATO board connection lost; ATO board failure
ATO RTD reading out of range
SD card removed during update
25-hour or customer-set timer has expired.
Oil may be present in the filter pan.
Recovery time exceeded maximum time limit.
Recovery time should not exceed 1:40 for
electric.
Oil temperature has dropped 30°F (17°C) lower
than setpoint in idle mode or 45°F (25°C) in cook
mode. (This message may appear if a product is
dropped and the start cook button is not pressed
immediately or if too large of cook loads are
dropped.)
1-23