Powerware 9 Prestige Series User Manual page 44

Installation
36
Only qualified service personnel (such as a licensed electrician) should perform the
hardwired installation.
8. Refer to your national and local electrical codes for acceptable
external wiring practices.
9. Remove the three screws on the terminal block access cover
with a Phillips screwdriver and remove the cover (see Figure 7).
For PowerPass systems with hardwired outputs, overcurrent protection and suitably
rated disconnect switches for the output AC circuit(s) are to be provided by either the
protected equipment or the customer's distribution panel.
10. Connect standard half-inch conduit through the terminal access
box (see Figure 7) and hardwire to the terminal block.
Figure 8. Hardwired PPDM Terminal Block
Powerware
W A R N I N G
C A U T I O N
CUSTOMER
INPUT OUTPUT
100/120V
L N L N
G L N L N G
N N
D D
INPUT OUTPUT
9 Prestige Series User's Guide (3000 VA)
®
:
www.powerware.com