Kenwood TK-3207 Service Manual page 10

TK-3207
2. Mounting the chassis to the case assembly.
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
groove of the chassis
2. Twist the speaker wires twice, then attach the speaker to
the speaker recess of the case assembly
the speaker is securely inserted.
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
3. Insert the upper part of the chassis into the case assembly
c
.
Caution: Take care that the speaker lead wire is not caught
by the microphone element.
v
4. Press the chassis
attach them.
Caution: If the packing of the SP / MIC does not come to the
correct position after attaching the chassis to the
case assembly, reposition the packing with your
fingers.
10
DISASSEMBLY FOR REPAIR /
z
.
x
. Make sure
1
and the case assembly together to
维修拆卸
2. 安装机壳和机架
1. 确认机架四周的防水垫是否确实地进入机架的槽里
2. 先将扬声器的两根引线扭在一起转 2 圈，然后把扬声器安装
到机壳的扬声器安装部
2
3. 把机架上侧插到机壳内
注意∶请不要使扬声器引线勾住麦克风。
4. 下按机架 v ，使机架和机壳合为一体并安装好。
注意∶把机架安装到机壳后，如果 SP / MIC 的橡胶垫不在正常
的位置时，请用手指将其调整到正常的位置。
3
4
4
z
。 确保扬声器完全被插入。
x
确认防水垫是否确实
地进入机架的槽里
c 。
。