Page 1
FYLDE MICROSYSTEMS Ltd Technical Manual TK255/355 Test Modes for version 0.99 Portable software Prepared by Brian Seedle BETA TEST KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (1)
TEST MODE 1. Test mode 1 is entered by powering up the mobile with the Programming Cable inserted in the microphone/speaker socket and then DGT button held. The display shows KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (2)
Page 3
DGT button held and the Reset key held.. The Squelch defeat operates in the same way as test mode 1. The display shows Removing the link will program the synthesiser to Test Channel 1. KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (3)
Page 5
Rx Ch 30 Tx Ch 30 KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (5)
Page 6
Connect the portable to a suitable R.F transmitter test set. Press the PTT to transmit. While transmitting, the encoder will increase or decrease the speech deviation. Note that the small digits on the left of the display will show the encoder value. KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (6)
Page 7
Set the level from the signal generator to the point at which the squelch will be adjusted. Turn the encoder to a point whereby the squelch just opens. If the squelch is open the green LED will illuminate. KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (7)
Page 8
If there is no factory channel table has been loaded into the portable using the program KENENG then it will not be possible to use this test. KENWOOD TRUNKED PORTABLE - Test Modes Ver 0.99 Page (8)