Table of Contents
Advertisement
Preparing the Answering System
To erase the recorded greeting message
Press
(GREETING)
played.
The unit will answer a call with a pre-recorded greeting.
Pre-recorded greeting message
If you do not record a greeting message (p. 21), one of two messages will
be played when a call is received, depending on the caller's recording
time (p. 26).
To check the pre-recorded greeting, press
A pre-recorded greeting will be played as follows:
When the recording time is set to "1 minute" or "3 minutes":
"Hello, we are not available now. Please leave your name and phone number
after the beep. We will return your call."
When the recording time is set to "Greeting only":
"Hello, we are not available now. Please call again. Thank you for your call."
Flash Memory Message Backup
Messages are stored on a "flash memory" IC chip and will not be
affected by power failures. All messages are saved until you erase
them.
22
briefly \ press
while the message is being
(ERASE)
(GREETING)
briefly.
Advertisement
Table of Contents
