Setup Without Q-Link (Automatic Tuning) - Panasonic DMR-ES30VEB Operating Instructions Manual

Setup without Q-Link
(Automatic Tuning)
Auto-Setup
Ch
Auto-Setup in progress, please wait.
Suche Sender, bitte warten.
RETURN: to abort
RETURN: abbrechen
RETURN
Owner ID
PIN number
* * * *
Name
* * * * * * * * * * * * * *
House No.
* * * * * * * * * * *
Postcode
* * * * * * * * * * *
RETURN
RETURN : leave
Clock
Time
: :
0 00 00
No
0 9
Clock cannot be set automatically.
Please set the clock manually.
CHANGE
SELECT
ENTER: store RETURN: leave
ENTER
RETURN
Auto-Setup
The automatic setup saves all available TV stations. If the station also broadcasts date
and time, then the clock is also set automatically.
Switch on your television and select the AV channel.
35 4
With the Stand-by/on switch turn on the DVD Recorder.
Automatic tuning for all available TV stations begins.
Approximate duration is 5 minutes.
After Automatic tuning has finished, press RETURN.
The Owner ID screen will appear.
Owner ID
You can complete the Owner ID now or skip this step and do it later. To do it later, press
the RETURN button. Your DVD Recorder is now ready to use.
To set the Owner ID now, use
four-digit PIN number. Press , to correct the digit.
Make sure that you will remember the PIN number (make a note of it).
Press the ENTER button twice to confirm.
Enter the [Name], [House No] and [Postcode] in the same way, using
Press the ENTER button to confirm each entry.
Press the RETURN button to leave the Owner ID screen.
You will now see the TV picture. Your DVD Recorder is now ready to use.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
Automatic Off
Press
Date
. .
1 1 2005
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
If Auto-Setup has previously been completed the DVD Recorder will not start Auto-Setup
automatically. In this case you can re-start Auto-Setup again. See page 72.
If you want to cancel Auto-Setup before it has finished, press the RETURN button.
You can restart Auto-Setup again. See page 72.
and press the Numeric buttons or
to set the correct time and date and press ENTER to finish this setting.
to enter a
.
17