Download Print this page

Extron electronics CCI Pro 700 Setup Manual page 4

Touchlink pro conference room control interface
Hide thumbs Also See for CCI Pro 700:

Advertisement

Reset Modes
The reset modes set various device settings back to default values. To activate the
reset modes, use an Extron Tweeker or small screwdriver to access the recessed
reset button (see
to the right) on the rear panel.
A
Factory firmware — To temporarily revert back to factory default firmware for a
single power cycle, hold down the Reset button while applying power. Do not
operate the device with this firmware. Use this to install new firmware if a previous
attempt failed.
Reset all IP settings — To reset the IP settings to factory defaults, hold down the
Reset button until the Reset LED blinks two times (over approximately 6 seconds
in 3 second intervals). Then, release and press the Reset button momentarily
(for <1 second) within 1 second. The following settings are reset:
LAN IP settings
DHCP (off)
Host name
Domain name
When complete, the Reset LED blinks three times in quick succession.
Reset to factory defaults — To reset the device to all default settings and delete all uploaded files, hold the Reset button until
the Reset LED blinks three times (over approximately 9 seconds in 3 second intervals). Then, release and press the Reset button
momentarily (for <1 second) within 1 second. When complete, the Reset LED blinks four times in quick succession.
Pull-Out Tray
The pull-out tray (see
figure
location to store important information. Use the provided label to store the
information on the pull-out tray.
NOTE:
To use labels other than the provided one, ensure the
dimensions do not exceed 2 inches wide by 2.625 inches high.
Alternatively, some labels, such as the Avery
be printed from a computer (see the label manufacturer for more
details on labels not provided by Extron).
Carefully remove the pull-out tray completely from the base (
1.
Write the desired information on the label.
2.
Remove the label from the liner, exposing the adhesive side.
3.
Place the label on the designated location of the pull-out tray (
4.
Place the pull-out tray back in the base.
5.
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West
Extron USA - East
+1.714.491.1500
+1.919.850.1000
+1.714.491.1517 FAX
+1.919.850.1001 FAX
©
2016 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
4
IP address (192.168.254.251)
Subnet mask (255.255.255.0)
Gateway IP address (0.0.0.0)
DNS IP address (127.0.0.1)
1,
on page 2) provides a convenient
M
#6572 label, can
®
Extron Europe
Extron Asia
Extron Japan
+800.3987.6673
+65.6383.4400
+81.3.3511.7655
Inside Europe Only
+65.6383.4664 FAX
+81.3.3511.7656 FAX
+31.33.453.4040
+31.33.453.4050 FAX
A
).
1
).
2
Extron China
Extron Middle East
+86.21.3760.1568
+971.4.299.1800
+86.21.3760.1566 FAX
+971.4.299.1880 FAX
Label
2
1
Tray
Extron Australia
Extron India
+61.8.8351.2188
1800.3070.3777
+61.8.8351.2511 FAX
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
68-2785-50 Rev. A
www.extron.com
03 16

Advertisement

loading