Table of Contents
Advertisement
Problem
The display goes to the
standby mode while viewing
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller's
phone number.
(HANDSET\LOCATOR)
not function.
You cannot redial by
(REDIAL/PAUSE)
pressing
"Recharge battery" is
displayed, "
" flashes
or the unit beeps
intermittently.
You charged the battery
fully, but "Recharge
battery" is still displayed
and/or "
" continues to
flash.
Cause and Remedy
≥Do not pause for over 60 seconds while
searching.
≥The line mode selection is incorrect. See
page 13.
≥Your Caller ID service provider does not
support this feature.
does
≥The handset is too far from the base unit.
≥The handset is engaged in an outside
call or is viewing the Caller List/directory
list. Wait until the IN USE/CHARGE
indicator light goes out.
≥If the last number dialled was more than
.
32 digits long, the number will not be
redialled correctly.
≥Access numbers entered after pressing
(TONE)
will not be included when
redialling.
≥Charge the battery fully (p. 11).
≥Clean the charge contacts and charge
again (p. 12).
≥Install a new battery (p. 49).
"
53
Advertisement
Table of Contents
