Panasonic BT-3DL2550E Operating Instructions Manual page 18

How to Use the On Screen Menu
Picture/volume adjusting menu
Sharpness display
FUNCTION display
F1:MARKER
F2:CROSS HATCH
F3:BLUE ONLY
F4:TIME CODE
F5:LEVEL METER
Audio level meter display
1 1
3 3
5 5
7 7
Channel Level
display display
18
XXXXX
2 2
4 4
6 6
8 8
0 dB line
(continued)
• Press the ADJUST button (
picture/volume adjusting menu.
• To clear the display, press the ADJUST button again,
press the MENU button or leave it idle for 10 seconds.
• Only adjustments that appear on the screen can be
adjusted.
• The display always appears in the same screen
location.
• This is the SHARPNESS H/V mode display.
• It disappears after 2 minutes of inaction.
• Displayed when setting SHARPNESS H in 3D mode.
• Use the menu to open and set up functions.
• When "FUNCTION DISPLAY" (
"ON1" or "ON2", pressing any of the "FUNCTION1" to
"FUNCTION5" buttons displays the item and the
status of the item for the respective FUNCTION.
• This display disappears after 2 seconds of inaction.
• "XXXXX" indicates operating status (
"Functions and operating status displayed on screen
when FUNCTION buttons are pressed").
• A white skeleton bar meter indicates the audio level
for SDI signals. When 3D mode is set to SIMUL, audio
from the SDI signal input via SDI1 is always used.
• You can switch the level display on/off and set the
number of displayed channels using the menu
( page 42, "AUDIO").
• The 0 dB line and channel display can be switched
on/off from the menu (
Note:
When SDI2 and another input (except for a
combination of SDI1 and SDI2) are used for the split
screen display, TIME CODE and audio level meter
display will not function. In this case, use SDI1.
page 13, ) to open the
9
page 36) is set to
page 38,
page 42, "AUDIO").