Advertisement
Fourth
Turn the valet switch on then off
Press transmitter Lock button to change
or
Fifth
Turn the valet switch on then off
Press transmitter Lock button to change
or
Sixth
Turn the valet switch on then off
Press transmitter Lock button to change
or
Seventh Turn the valet switch on then off
Press transmitter Lock button to change
Press transmitter lock button to change
or
Press and release the valet switch
or
Turn ignition key off
Note: Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the system, and tested any and all optional features of the system:
1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain that the
chosen mounting location will not inhibit any of the controls of the vehicle.
2. Securely harness and tie all wiring up and away from all hot and moving parts that they may come in contact with under
the dash board or in the engine compartment areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as wires can wrap around these
mechanisms and impair the safe operation of the vehicle.
3. Check the vehicle's wipers, lights, horn, etc... to insure proper operation.
4. Replace all panels that were removed during installation, and retest the system.
5. Explain the operation of the system and its various features to the end user if available and place the Owner's Manual
on the dashboard for them to find and review.
1 chirp = chirps on
2 chirps = chirps off
2 chirps = active locks
1 chirp = passive locks
2 chirp = horn output
1 chirp = siren output
1 chirp = 800ms door lock output
2 chirps = 3.5 second door lock output
3 chirps = 800ms lock dbl 800ms unlock
Exit program mode
Exit program mode
7
4 Flash pause
5 Flash pause
6 Flash pause
7 Flash pause
128-6711
7 of 8
Advertisement
