Activating the ABS
4
function
34
z
Press and hold down button 1
until the ABS warning light
changes status.
ABS warning light goes out;
if self-diagnosis has not
completed it starts flashing.
Release button 1 within two
seconds.
The ABS warning light re-
mains off or continues to
flash.
The ABS function is activated.
You also have the option of
switching the ignition off and
then on again.
An ABS fault has occurred
if the ABS warning light
shows when the motorcycle ac-
celerates to a speed in excess
of 5 km/h after the ignition was
switched off and then on again.
Clutch
Adjusting clutch lever
Attempting to adjust the
clutch lever while riding the
motorcycle can lead to accidents.
Do not attempt to adjust the
clutch lever unless the motor-
cycle is at a standstill.
Turn adjusting screw 1 to the
desired position.
The adjusting screw is
easier to turn if you push
the clutch lever forward.
Adjustment options:
From position 1: smallest span
between handlebar grip and
clutch lever
To position 3: largest span
between handlebar grip and
clutch lever