Selecting A Logo At Startup; Specifying Power Management Mode - Canon WUX6000 User Manual

Customizing System Operation (System Settings)
Selecting a Logo at
Startup
> [System settings] > [User screen
settings] >
HDMI
Digital PC
You can display a specified logo on
the screen from the moment the
projector is turned on to the moment
it is ready for projection.
Skip
Canon
logo
User logo
Press the OK button to accept your
setting and then press the MENU
button.
• [Canon logo] is the factory default.
Downloaded From projector-manual.com Canon Manuals
[Projector on]
Component
Analog PC
Projects an input signal
immediately after turning on
the projector.
Displays the Canon logo that
was registered in advance at
the factory.
The user logo is projected.
Specifying Power
Management Mode
> [System settings] >
management mode]
LAN HDMI
USB Digital PC
You can specify to turn off the lamp
or projector automatically after a
certain period if the projector and
remote control are not used and
there is no input signal.
Disabled
Lamp off
Standby
Press the OK button to accept your
setting and then press the MENU
button.
• [Standby] is the factory default.
• After the lamp is turned off, projection
resumes when the same input signal is
restored, or when the remote control or
projector is operated.
• After the projector enters standby, restoring
projection requires the same steps as when
turning the projector on normally.
• When [Disabled] is selected, [Direct power
on] (P99) is not available.
98
[Power
Component
Analog PC
Disable power management
mode.
Only turns the lamp off.
Turns the projector off and puts
it in standby.
LAN
USB