Operation Menu - Panasonic AJ-D230H Operating Instructions Manual

Set-up Menus

OPERATION menu

Item
S u p e r i m p o s e d
No.
d i s p l a y
1 0 0 LOCAL
ENABLE
1 0 1 TAPE TIMER
1 0 2 S/F/R EE SEL 0000
1 0 3 WIDE MODE
104 TAPE IN MODE 0000
TAPE END
1 0 5
MODE
1 0 6 SERVO REF
(AUTO) VIDEO IN connector:
Synchronized playback is performed using standard video signals.
With non-standard video signals, the switching is performed in such a way that playback is
synchronized with the internal signals.
(EXT) SYNC IN connector:
Use standard signals as the SYNC signals.
Non-standard signals cannot be used. Use of the BB (black burst) signal is recommended.
When an out-of-sync state occurs due to SYNC signal switching or interruption
Set to the STOP EE mode or eject the cassette and then re-load it.
This makes it possible for the synchronization to be reset.
107 AUTO BACK
The underlined number and item are the factory settings.
Setting
S u p e r i m p o s e d
No.
d i s p l a y
0000 This selects the switches on the front panel which can
DISABLE
0001 ST EJ be operated in the remote control mode.
0: None of the switches can be operated.
1: Only the STOP and EJECT switches can be operated.
0000 12H
This selects the CTL counter display.
0001 24H
0: ±12-hour display
1: 24-hour display
EE
This selects the EE/VV output during stop, fast
TAPE
0001
forwarding or rewinding.
0: EE is output.
1: VV is output.
0000
This selects the WIDE mode.
AUTO
0001
0: Automatic detection.
WIDE
0002
NORMAL 1: The screen mode is forcibly treated as WIDE.
2: The screen mode is forcibly treated as NORMAL.
STOP
This selects the operation which follows when the
0001
REW
cassette is inserted.
0002
PAUSE
0: STOP
0003
PLAY
1: Rewind
2: Play pause
3: Play
0000
STOP
This selects the operation which follows when the tape
0001
REW has reached the end.
0002 R E W E J 0: Stop
0003 EJECT 1: Rewind
2: This rewinds the tape and ejects it upon completion
of rewinding.
3: Eject
AUTO
0000
This selects the sync signals of the servo.
EXT
0001
0: Synchronization with the input signals; if no input
signals are present, synchronization with the internal
signals.
1: During playback, synchronization with the SYNC IN
signals;
synchronization with the internal signals.
OFF This selects whether to automatically reverse (auto
0000
0001 ON back) the tape to achieve back-space assemble
recording.
0: No auto back
1: Auto back
25
Description of settings
if these signals are not present,