Airlink101 AR686W User Manual page 66

For each rule, you can define:
Source IP address
•
Destination IP address
•
Destination port address
•
Protocol: TCP or UDP or both.
•
Parameters
Outbound
Packet Filter
Allow / Deny all to pass except
those match the following rules
Source IP
Destination IP
Port
Enable
Schedule Rule#
Description
Check/uncheck Enable to enable/disable the Packet Filtering.
Outbound Filter applies on all outbound packets but Inbound
Filter applies only on packets that are destined to Virtual Servers
or DMZ host.
Please select "Allow" or "Deny" to decide the behavior of packet
filtering table. If you select allow, all traffic will be allowed except
the Source IP addresses listed in filtering table will be rejected to
connect to the destination IP addresses and ports. If you select
deny, all traffic will be denied except the Source IP address listed
in filtering table will be allowed to connect to the destination IP
addresses and ports.
Please input the client's IP address you wish to apply the filtering
rule. You can input a single IP address (192.168.2.10) or a range
of IP addresses (192.168.2.10-192.168.2.50). Leaving this field
blank indicates all IP addresses.
Please input the Destination IP address (i.e. an FTP site, Email
server, etc.) you wish to apply the filtering. You can input a single
IP address (192.168.2.10) or a range of IP addresses
(192.168.2.10-192.168.2.50), leaving this field blank means all IP
addresses.
Please input the port number here. You can define a single port
(80) or a range of ports (1000-1999). Add prefix "T" or "U" to
specify TCP or UDP protocol, for example, T80, U53,
U2000-2999. No prefix indicates both TCP and UDP are defined.
Leaving this field blank indicates all ports.
Check/uncheck Enable to enable/disable each Packet Filtering
rule.
Enter a Schedule Rule number to activate the filtering rule only
within the desired time frame. Please refer to 3.4.7 Schedule
62