Table of Contents
Advertisement
Trigger
Incoming Ports
Enable
Note: Only one PC can use each Special Application tunnel at same time.
If the mechanism of Special Applications fails to make an application work, try setting
your computer as the DMZ host instead, please refer to Section 3.2.3 Miscellaneous for
details .
Click Save after you finished all settings.
3.2.3 Miscellaneous
If you have a local client PC that cannot run an Internet application (e.g. Games) properly
from behind the NAT firewall, then you can open the client up to unrestricted two-way
Internet access by defining a DMZ Host. The DMZ function allows you to re-direct all
packets going from your WAN port IP address to a particular IP address in your LAN.
You can configure DMZ at this page, as well as UPnP and other settings.
Parameter
IP Address of DMZ Host
applications, and the ID you wish to fill the setting in. Click Copy
to and the setting you selected will be filled into the specific ID.
Enter an outbound port number assigned by the application.
When the trigger packet is detected, the inbound packets to the
specified port numbers are allowed to pass through the NAT
firewall, type in a range of incoming ports to be triggered, for
instance, "5000-5300" or "9091, 9093-9100". It depends on the
special application's requirement.
Check to enable this Special Application rule.
Description
Enter the local IP address that you wish to open DMZ. If the
58
Advertisement
Table of Contents
