2
Left
3
Function
4
Mini USB charge
connector
5
LED indicators
6
Right
7
Power switch
8
Firmware upgrade
connector
OSD warning messages - low battery
• The Low Battery warning message pops up when the battery voltage is
• The pen will be disabled when the battery voltage is lower than 1.8 V.
Combinations of buttons
• Left + Function: The Pen Information menu appears on the screen.
• Hold Function: Hold the Function button for 2 seconds and the
• When Toggle is selected in the Set Function menu, press the Function
NOTE:
"Switch primary and secondary buttons".
Downloaded From projector-manual.com DELL Manuals
lower than 2 V. At this condition, the pen can still work about 1~2 hours.
Function mean will appear on the screen. Use Left/Right to move
up/down and use Function to enter/apply.
button to select Normal/Draw/Stable mode.
Interactive pen cannot support Windows Mouse property function
This button acts like the left click button of a
mouse.
Functions available are listed in the OSD Menu
"Set function" (see page 70).
NOTE:
Double-clicking the Function button
will act as Undo, if supported by the
software.
Allow you use Mini USB cable to charge. See
"Charging the Interactive Pen Battery" on page
44.
Two LED indicators are available: Green and
Amber (see "Interactive Pen LED Guiding
Signals" on page 133).
This button acts like the right-click button of a
mouse.
Turns the Interactive Pen on or off.
For Interactive Pen and RF board firmware
upgrade.
Using Your Projector
41