Panasonic Panaboard KX-BP800 Operating Instructions Manual page 15

4 Load the thermal transfer film into the film
cassette.
CLoad the thermal transfer film into the film
cassette so that the blue gear inserted in the
thermal transfer film is located on the blue label
side of the film cassette. Push in the direction
of the arrow until you hear all four gear shafts
click in place.
5
If the thermal transfer film is slack, take up the
slack by winding the gears on the label side of
the cassette in the direction of the arrows.
CThe multi-copy/error indicator may flash
" " if the thermal transfer film is slack.
In addition, the thermal transfer film may
wrinkle, and blank (unprinted) spots or black
streaks may appear on the copy paper.
6
Install the film cassette.
CInsert the film cassette into the printer so that
the blue gear on the cassette aligns with the
blue label on the printer and then insert the
gear shafts on both sides of the cassette into
the grooves inside the printer.
CIf the film is slack after loading the film
cassette, take up the slack in the same manner
described in step 5 while the cassette remains
loaded.
7 Close the printer door.
CSecurely close the printer door by using both
hands until a click is heard.
CThe "
" flashing on the multi-copy/error
indicator will go out.
Note
CIf the flashing "
though the printer door has been closed, this
indicates that the film cassette has not been
installed properly or that there is slack in the
thermal transfer film. Check the condition of the
film cassette and for slack in the thermal
transfer film.
" does not go out even
Installing Thermal Transfer Film
Thermal
Blue Label
Transfer Film
Blue Gear
Film Cassette
Label
Slack Prohibited
Blue Label
Grooves
Load thermal transfer
film in this derection
Thermal
Transfer Film
Grooves
Printer Door
15