Connections - JVC UX-E8DAB Instructions Manual

Connections

Do not connect the power cord until all other connections have been made.
NOTES
• Make sure the antenna conductors do not touch any other terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System, connecting cords, and the power cord. This could cause poor
reception.
• If the cords are covered with vinyl, remove the vinyl to expose the tip of the cord by twisting it.
• DO NOT connect more than one speaker to each terminal.
• DO NOT allow the conductor of the speaker cords to be in contact with any metallic parts of the System.
AM loop antenna (supplied)
Turn it until the best reception is
obtained.
To a wall outlet
Plug in the power
cord only after all
connections are
complete.
3
To assemble the AM loop antenna
DAB antenna (supplied)
Extend the wire so that you can
receive your desired ensembles.
To connect the AM loop antenna
To connect the speaker cords
Make sure both speakers are connected correctly and firmly.
• Before connecting the speaker cords, twist and pull the
insulation coat off.
When connecting the speaker cords,
match the polarity of the speaker
terminals: black cord with white
stripe to (+) and black cord to (–).