JVC UX-E8DAB Instructions Manual page 24

Listening to the Radio (see pages 10 to 13)
• The time shown on the display is based on the built-
in clock of the System, not on the information sent
through DAB or Radio Data System.
• If you want to know more about Radio Data System, visit
<http://www.rds.org.uk>.
Listening to an iPod (see page 14 to 15)
• The iPod battery cannot be charged while the System is
in Save Mode.
• When the battery charge function (see page 15) is
turned off, the iPod may not be turned on from the
System.
• You cannot send any data to your iPod from the System.
• Sound distortion may occur when playing back audio
sources with high recording levels. When distortion
occurs, it is recommended to turn off the equalizer of
the iPod. For information on operating the iPod, see the
iPod instruction manual.
• Do not hit or touch the iPod terminal pins or connector
pins directly. This could damage the connector part.
• Do not carry the System with iPod connected. You
might drop it or it might cause damages to the
connector part.
19
Listening to a Digital Audio Player (see page 16)
• When the sound signal from the Digital Audio Player
is too weak, QP Link may not function correctly. In this
case, turn up the volume of the Digital Audio Player so
that the System can detect the sound signal properly.
• Changing from LINE to another source while QP Link is
working will deactivate QP Link temporarily. In this case,
the following will reactivate QP Link:
– Pressing and holding QP LINK on the remote control.
– When no sound signal comes from the LINE IN jack for
about 30 seconds after the System has been turned
off.
• If you press the button to turn the System off or if
the preset Timer turns the System off while QP Link is
working, the System deactivates QP Link temporarily. In
such cases, the following will reactivate QP Link:
– When no sound signal comes from the LINE IN jack for
about 30 seconds after the System has been turned
off.
– When you turn on the power again.
• Before recording on a Digital Audio Player, deactivate QP
Link or disconnect the Digital Audio Player from the LINE
IN jack; otherwise, LINE will be selected as the source
and the recording will stop.
• Sound adjustments (see page 6) do not affect the sound
recorded on the Digital Audio Player.
Setting the Clock and the Daily Timer (see page 17)
• "0:00" flashes on the main display until you have set the
clock.
• The clock may gain or lose 1 to 2 minutes per month. If
this happens, readjust the clock.
• When you unplug the power cord or if a power failure
occurs, the clock and the timer will be canceled. You
need to set the clock first, then the timer again.
• If you set the Sleep Timer after the Daily Timer has
started playing the selected source, the Daily Timer is
canceled.