Panasonic BT-LH900A Operating Instructions Manual page 22

MAIN MENU
(continued)
INPUT SELECT
Item Setting
FORMAT AUTO For selecting the signals whose input is to
1080/60I be accepted in the YP
1080/50I RGB mode.
1080/30P The signals can be set for each mode, and
1080/25P when the MODE item setting is switched
1080/24P from YP
1080/24PsF mode is automatically switched so that the
1035/60I signal format which has been set for the
720/60P mode now set is accepted.
720/50P AUTO:
576/50I
480/60P 1080/60I:
480/60I
1080/50I:
1080/30P:
1080/25P:
1080/24P:
1080/24PsF:
1035/60I:
720/60P:
720/50P:
576/50I:
480/60P:
480/60I:
COMPONENT SMPTE For selecting the input level of the Y/P
LEVEL B75 signals.
SMPTE: This is selected when the signals
B75:
RGB-SYNC G-ON For switching the connector where the sync
EXT signal is to be accepted.
G-ON: This is selected when the sync
EXT: The sync signal is accepted at the
The underlined setting indicates the factory setting mode.
22
Description
P mode and in the
B R
P to RGB or vice versa, the
B R
All supported signals are accepted.
1080/60I or 1080/59.94I format signals
are accepted.
1080/50I format signals are accepted.
1080/30P or 1080/29.97P format signals
are accepted. (This setting takes effect
only when YP P is selected.)
B R
1080/25P format signals are accepted.
(This setting takes effect only when
YP P is selected.)
B R
1080/24P or 1080/23.98P format signals
are accepted. (This setting takes effect
only when YP P is selected.)
B R
1080/24PsF or 1080/23.98PsF format
signals are accepted. (This setting takes
effect only when YP P is selected.)
B R
1035/60I or 1035/59.94I format signals
are accepted. (This setting takes effect
only when YP P is selected.)
B R
720/60P or 720/59.94P format signals
are accepted.
720/50P format signals are accepted.
(This setting takes effect only when
YP P is selected.)
B R
576/50I format signals are accepted.
480/60P format signals are accepted.
480/59.94I format signals are accepted.
are to be output from an MII VTR.
This is selected when the signals
are to be output from a Betacam
VTR.
signal has been superimposed onto
the G signal.
SYNC connector among the analog
component/RGBS connectors.
CONTROL
Item Setting
CONTROL LOCAL
REMOTE
LOCAL ENA DIS.
INPUT
BACKLIGHT TIME
/P
B R
Description
For selecting where the operations are to
be initiated.
LOCAL: Only operations initiated from the
main controls can be performed.
Remote control operations cannot
be performed.
REMOTE: Remote control operations can be
performed, but no operations
initiated by the main controls can
be performed although there are a
few exceptions to this.
<Notes>
≥ When REMOTE has been selected, the
" " lock mark appears on the status
display.
≥ When REMOTE has been selected, only
the settings of the CONTROL item and
LOCALENABLE item on the CONTROL
screen can be changed as menu
operations.
For selecting whether to enable the input to
be switched to the main controls when
REMOTE has been selected.
DIS: When REMOTE has been selected,
the input can no longer be switched
to the main controls.
INPUT:Even when REMOTE has been
selected, the input can be switched
to the main controls.
For displaying the total operation time of
the backlight.