Table of Contents
Advertisement
LSQT1025(ENG).book 130 ページ ２００６年２月４日 土曜日 午後６時１０分
Connection and recognition
Connection and recognition
Connection and recognition procedures
After the driver and software applications are installed, the unit must be connected to the computer
and be correctly recognized by the computer.
≥ Connect after installing the driver and software applications.
≥ If the supplied CD-ROM is inserted in the computer, remove it. (If the [Setup Menu] is running,
wait until it finishes, then remove the CD-ROM.)
≥ If the recognition procedure is not accomplished properly, operation will not be possible after
connecting the unit to the computer.
≥ If the unit fails to operate normally, it may mean that you have not conducted the installation or
recognition procedure properly.
≥ Be sure to finalize DVD-RW (VR format), DVD-RW (Video format) and DVD-R on this unit,
before using them on the computer. Un-finalized discs will not be recognized by the
computer.
¬ Connect this unit to the AC adaptor.
1 Insert a disc or card with recorded images in the unit,
then select the unit's operation mode.
and
When using a disc: Select
When using a card: Select
2
(Only in card playback mode)
Press the MENU button, then select [
# [
USB FUNCTION] # [PC CONNECT] and
press the joystick.
≥ Press the MENU button to exit the menu screen.
3 Connect this unit and a computer.
A USB cable (supplied)
≥ Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
This unit is automatically recognized by the computer.
≥ Do not use any other USB cables except the supplied
one. (Operation is not guaranteed with any other USB
cables.)
130
LSQT1025
.
.
SETUP]
turn on the unit
A
Advertisement
Table of Contents
