Table of Contents
Advertisement
3
Setup
SD cards are sold separately.
Preparations: Set the mode dial to [OFF].
(Check that the status indicator is out.)
Inserting or removing an SD card with the power ON may
damage the unit and destroy data on the card.
Open the card/battery
1
door.
Open the door by sliding the card/
battery door lever to the "OPEN"
position.
Insert/Remove the SD
2
card.
•
To insert:
Face the label upwards and slide
the card in straight until hearing it
catch.
•
To remove:
Press the center of the SD card and
pull the card out straight.
Close the card/battery
3
door.
•
Close the card/battery door and
slide the card/battery door lever to
the "LOCK" position.
•
If the door does not close
completely, remove the SD card,
check its orientation and reinsert it
into the slot.
●
While the card access lamp is lit, reading, recording, playback, deletion
or other processing is being executed. Performing the following
operations while the lamp is lit may damage the SD card and its content
and the unit may not function properly.
• Switching off power
• Removing battery or AC adaptor
• Opening card/battery door and removing SD card
• Rotating the mode dial
• Shaking or impacting the unit
• Disconnecting the USB cable
●
The access lamp is supposed to light up while rotating the dial to select
a mode. In this case, there is no problem.
Inserting/Removing SD
cards
(sold separately)
Place label upwards.
Card access lamp
LSQT1426
23
Advertisement
Table of Contents
