Charging Time And Available Recording Time; To Use As A Grip Belt; Re-Attaching The Lens Cap - Panasonic PV-GS16 Operating Instructions Manual

2
Attach the charged Battery to the
Camcorder.
Disconnecting the Power Source
Set the [OFF/ON] Switch
sliding the [BATTERY RELEASE] Switch
remove the Battery downward or DC Cable.
• When attaching or removing Battery, set the
[OFF/ON] Switch to [OFF] and make sure the
[POWER] Lamp is not lit.
• For other notes concerning this item, see page 55.
Charging Time and Available
Recording Time
CGR-D08R
A Charging Time
Maximum Continuous Recording Time
B
• "2 h 10 min." indicates 2 hour and 10 minutes.
• Battery CGR-D08R is supplied.
• The times shown in the table are approximate
times. The numbers indicate the recording time
when the Viewfinder is used. The numbers in
parentheses indicate the recording time when
the LCD Monitor is used. In actual use, the
available recording time may be shorter.
• The times shown in the table are for continuous
recording at a temperature of 68 °F (25 °C) and
humidity of 60 %. If the Battery is charged at a
higher or lower temperature, the charging time
may be longer.
• The available recording time becomes shorter
if you use both of Viewfinder and LCD Monitor
simultaneously when rotating the LCD Monitor
forward to record yourself or setting [EVF ON/
AUTO] to [ON].
14
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
42
to [OFF], and while
46
42
46
A 1 h
B 2 h 10 min. (1 h 45 min.)
Before Use

To Use as a Grip Belt

Adjust the length of the Grip Belt to the size of your
hand.
1
Detach the end of the Grip Belt.
2
Adjust the length of the Grip Belt to the size
of your hand.
,
3
Reattach the Grip Belt.

Re-attaching the Lens Cap

To protect the Lens surface, attach the Lens Cap.
• The Lens Cap and Lens Cap Cord come
preattached to the Grip Belt.
1
Pass one end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then
pass the Lens Cap through the loop made
by itself and pull tight.
• When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow.
• When you are not recording, be sure to cover the
Lens with the Lens Cap for protection.
1
1
2
2