Table of Contents
Advertisement
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which au-
tomatically lights the pilot. Do not try to light the pilot by hand,
use the remote control. Before lighting the pilot, ensure that the
main on/off switch is on. When lighting the pilot, follow these
instructions exactly.
B. Before lighting smell all around the appliance area for gas. Be
What To Do If You Smell Gas
•
Do not try to light any appliance.
•
Do not touch any electrical switch;
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone.
1.
STOP! Read the safety information above.
2.
Turn OFF electric power to the appliance.
3.
Remove front surround assemblies.
4.
Turn gas cock counterclockwise
5.
Wait ten minutes to clear out any gas. Then smell for gas,
the safety information above. If you do not smell gas, go to
the next step.
6.
Tun ON electric power to the appliance.
7.
Find pilot. The pilot is behind the burner.
using your remote. If the pilot does not light within 60 seconds,
stop and go to step 5.
1.
Turn off all electric power to the appliance if service is to be
performed.
2.
Gain access to the control compartment by removing surround
assemblies.
35362-3-1015
LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO FIREPLACE
Follow the gas supplier's instructions.
ment.
C. Use only the remote control to operate the gas valve. Never
use tools. If valve does not operate, don't try to repair it, call
D. Do not use this appliance if any part has been under water.
appliance and to replace any part of the control system and
any gas control which has been under water.
9.
If the burner or pilot does not operate properly after several
tries, turn the gas cock clockwise
your service technician or gas supplier.
10. Replace the front surround assemblies.
11. Operation of the gas valve is controlled by a hand held remote
control. Refer to remote instructions for detailed operation
information.
GAS COCK
3.
Locate On/Off gas cock and turn clockwise
Do not force.
4.
Replace surround assemblies removed in step 2.
-
Page 43
Advertisement
Table of Contents
Troubleshooting
