Table of Contents
Advertisement
VFp(32,36)Fp(30,31) LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result caus-
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF yOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch;
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1.
STOP! Read the safety information label.
2.
Open bottom louver assembly.
3.
Set REMOTE/OFF/ON switch to
"OFF."
4.
Turn off all electric power to the
appliance (if applicable).
5.
Push in gas control knob slightly and
turn clockwise
NOTE: Knob cannot be turned from
"PILOT" to "OFF" unless knob is pushed in
slightly. Do not force.
6. Wait ten (10) minutes to clear out any gas.
Then smell for gas, including near
the floor. If you smell gas, STOP!
Follow "B" in the safety informa-
tion above. If you do not smell gas,
go to the next step.
7. Find pilot - Follow metal tube from
gas control. The pilot is behind the
burner on the right side.
1.
Open bottom louver assembly.
2.
Set REMOTE/OFF/ON switch to "OFF."
3.
Turn off all electric power to the appliance if service is to be
performed (if applicable).
20101-5-0509
ing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
GAS CONTROL KNOB
GAS CONTROL KNOB
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
SHOWN IN "OFF" POSITION.
SHOWN IN "OFF" POSITION.
to "OFF."
PILOT
THERMOPILE
THERMOCOUPLE
THERMOCOUPLE
THERMOCOUPLE
(LPG)
(LPG)
(LPG)
THERMOCOUPLE
THERMOCOUPLE
THERMOCOUPLE
(NATURAL)
(NATURAL)
(NATURAL)
TO TURN OFF GAS TO APPLIANCE
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it; call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
8. Turn gas control knob counterclockwise
LOT."
9. Push in control knob all the way and hold in. Repeatedly
push the Piezo Ignitor Button until the pilot is lit. Continue
to hold the control knob in for about one (1) minute after
the pilot is lit. Release knob, and it will pop back up. Pilot
should remain lit. If it goes out, repeat steps 5 through 9.
•
If knob does not pop up when released, STOP and
IMMEDIATELY call a qualified service technician
or gas supplier.
REMOTE
REMOTE
REMOTE
OFF
OFF
OFF
•
If the pilot will not stay lit after several tries, turn
ON
ON
ON
the gas control knob to "OFF" and call your service
technician or gas supplier.
PILOT
PILOT
THERMOPILE
THERMOPILE
10. Turn gas control knob counterclockwise
ELECTRODE
ELECTRODE
ELECTRODE
"ON."
11. Set REMOTE/OFF/ON switch to desired setting.
12. Turn on all electric power to the appliance (if appli-
cable).
13. Close bottom louver assembly.
4.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
5. Close bottom louver assembly.
to "PI-
to
Page 17
Hide quick links:
Advertisement
Table of Contents
