Message Codes; Care; Warranty; Safety Instructions - Stanley TLM165I User Manual

Message Codes

If the message does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message appears with a
number, press the Clear button and
observe the following instructions:
No. Cause Correction
204 Calculation error Perform measurement
again.
252 Temperature too Let device cool down.
high
253 Temperature too Warm device up.
low
255 Received signal too Change target surface
weak, measuring (e.g. white paper).
time too long
256 Received signal too Change target surface
high (e.g. white paper).
257 Too much back- Shadow target area.
ground light
258 Measurement Correct range.
outside of meas-
uring range
260 Laser beam inter- Repeat measurement.
rupted

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents
or solvents.

Warranty

The Stanley TLM has a two-year warranty.
For further information on this, contact
your dealer.
Subject to change (drawings, descriptions
and technical data).
Stanley TLM165I

Safety Instructions

The person responsible for the instrument
must ensure that all users understand
these directions and adhere to them.

Areas of responsibility

Responsibilities of the manufacturer
of the original equipment:
Stanley Tools
701 E. Joppa Road
Towson, Maryland 21286
www.STANLEYLASERS.com
www.STANLEYTOOLS.com
www.STANLEYTOOLS.eu
The company above is responsible for
supplying the product, including the User
Manual in a completely safe condition.
The company above is not responsible for
third party accessories.
Responsibilities of the person in
charge of the instrument:
• To understand the safety instructions on
the product and the instructions in the
User Manual.
• To be familiar with local safety regula-
tions relating to accident prevention.
• Always prevent access to the product by
unauthorised personnel.
EN
11