Using The Menu Screen - Panasonic NV-DS60 Operating Instructions Manual

2, 3, 4, 5
1
PUSH
1
1, 2
PUSH
1 2
4 5
DELETE:M-DEL
PRESS STOP TO EXIT
14

Using the Menu Screen

To facilitate the selection of a desired function or setup, this
Movie Camera displays various function setups on Menus.
1
Press the [MENU] Button.
≥The Menu corresponding to the Mode selected by using
2
Turn the [PUSH] Dial to select a desired
Sub-Menu.
≥Turn the [PUSH] Dial to display the highlightened item.
3
Press the [PUSH] Dial to display the selected
Sub-Menu.
4
Turn the [PUSH] Dial to select the item to be set.
5
Press the [PUSH] Dial to set the selected item to a
desired mode.
≥With each pressing of the [PUSH] Dial, the cursor [1]
≥While a Menu is displayed, you cannot record or play back.
Menus can be displayed during playback but not during
recording. The above operations can be done using the
[MENU] Button, [SET] Button and [ITEM] Button on the
Remote Controller. (l 8)
To Exit the Menu Screen
Press the [MENU] Button again.
About the Menu Mode Setting
The setting selected on the Menu will be retained even when the
Movie Camera is turned off. (But, the setups of
[DIGITAL EFFECT] are not retained.) However, if the Battery or
AC Adaptor is disconnected before turning off the Movie
Camera, the selected setup may not be retained.
≥Menu operation flow is shown in this text by >>.
ª Image Selection in the Card Playback Mode
(NV-DS65 only)
An Image Selection Operation may be necessary during Menu
Operations. In this case, carry out the following procedure.
1
Turn the [PUSH] Dial and select a picture.
≥The selected picture is underlined
2
Press the [PUSH] Dial to confirm the selection of
the picture.
3
≥After the above Picture Selection Procedure, carry out the
2
various Menu Operations. (The above procedure will not be
6
repeated in the following instructions.)
D-000
the [VCR/OFF/CAMERA/M-CARD] Switch
moves to the next mode.
(l 40)
1
is displayed.
2
.