combination with front-wheel
adapter (83 30 0 402 242).
Loosen mounting bolts 1.
Push the two mounts 2 out-
ward, continuing until the front
suspension fits between them.
Adjust support pin to match
front suspension.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Install rubber buffer 4 on left
and right in upper position.
Align two mounts 2 so that
front suspension rests securely
on them.
Tighten securing screws 1.
Apply uniform pressure to push
front wheel stand down and
raise motorcycle.
Fuses
Removing fuse
If defective fuses are
bridged, this results in a
danger of short-circuit and thus a
danger of fire.
Replace defective fuses with new
fuses.
Switch off ignition.
Remove seat (
38).
8
81
z