Figure 111. RAID adapter battery or flash power module cable connection
Attention: Make sure that the cable is not pinched and does not cover any connectors or obstruct
any components on the system board.
Step 7.
Remove any cable covering or obstructing the holder before opening the holder.
Step 8.
Install the battery or flash power module:
a.
Release the retention clip in the open position.
b.
Align the cable connector with the slot on the holder. Place the battery or flash power module
into the holder and make sure that the holder engages the battery or flash power module
securely.
.
Chapter 6
Removing and replacing components
195