Setting Date And Time - Panasonic HDC-SD10PP Operating Instructions Manual

Preparation
7
Setup
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
¬ Change the mode to
1
Select the menu. (l 29)
[SETUP] # [CLOCK SET] # [YES]
2
Touch the date or time to be set,
then set the desired value using
/ .
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 12-hour system is used to display the time.
≥
appears on the right top of the screen
when [SET WORLD TIME] (l 35) is set to
[HOME], while
[DESTINATION].
3
Touch [ENTER].
≥ The clock function starts at [00] seconds.
≥ A message prompting for World time setting
may be displayed. Perform the World time
setting by touching the screen. (l 35)
≥ Touch [EXIT] or press the MENU button to
complete the setting.
Changing the date and time display mode
Select the menu. (l 29)
[SETUP] # [DATE/TIME] # desired display
style
34
VQT2H52

Setting date and time

.
appears when it is set to
[DATE]
NOV 15 2009
[OFF]
≥ The date and time disappear from the screen
after being displayed for a few seconds.
Changing the date format
Select the menu. (l 29)
[SETUP] # [DATE FORMAT] # desired
display style
Display style
[Y/M/D]
[M/D/Y]
[D/M/Y]
≥ The date and time function is driven by a built-
in lithium battery.
≥ If the time display becomes [- -], the built-in
lithium battery needs to be charged. To
recharge the built-in lithium battery, connect
the AC adaptor or attach the battery to this
unit. Leave the unit as it is for approx. 24 hours
and the battery will maintain the date and time
for approx. 6 months. (The battery is still being
recharged even if the power is off.)
[D/T]
12:34PM
NOV 15 2009
Screen display
2009. 11. 15
NOV 15 2009
15. 11. 2009