Table of Contents
Advertisement
Quick Guide
∫ Charging the battery
1 Connect the AC cable to the AC adaptor and
the AC outlet.
2 Insert the battery into the AC adaptor by
aligning the arrows.
∫ Inserting the battery
Open the LCD monitor and install the battery by
inserting it in the direction shown in the figure.
A Insert the battery until it clicks and locks.
∫ Inserting/removing an SD card
Access lamp [ACCESS] A
≥ When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
12
VQT2H52
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging completed
1) Open the SD card cover by sliding the OPEN
lever B.
≥ While sliding the lever, push up on the SD card
cover to open.
2) Insert/remove the SD card.
≥ Face the terminal side C in the direction
shown in the illustration and press it straight in
as far as it will go.
≥ Press the center of the SD card and then pull it
straight out.
3) Return the SD card cover to its original
position and press down to close.
≥ Securely close it until it clicks.
∫ How to turn on the power
Turning the power on and off with the power
button
Press the power button to turn on the power.
A Status indicator lights.
≥ To turn off the power, hold down the power
button until the status indicator goes off.
Turning the power on and off with the LCD
monitor
Power is turned on when the LCD monitor is
opened, and power is turned off when it is closed.
∫ To turn on the power
A The status indicator lights.
∫ To turn off the power
B The status indicator goes off.
Hide quick links:
Advertisement
Table of Contents
