Terminal Setup - Planet WGSD-10020 Series Quick Installation Manual

3. Terminal Setup

To configure the system, connect a serial cable to a COM port on a PC or notebook
computer and to RS-232 type of serial port of the Managed Switch.
PC / Workstation
with
Terminal emulation software
Figure 3-1: Managed Switch Console Connectivity
A terminal program is required to make the software connection to the Managed
Switch.
1. Run terminal program on the OS.
2. When the following screen appears, make sure that the COM port should be
configured as:
z Baud
z Data bits
z Parity
z Stop bits
z Flow control
RS-232
Serial Port
: 115200
: 8
: None
: 1
: None
Managed Switch
Serial Port
115200,8,n,1
Figure 3-2: COM Port Configuration
5