Building Code Information - Monessen Hearth AVFLST42NTSC Installation & Operating Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

IMPORTANT SAFETY INFORMATION

as they are burned off during the initial operation of the

appliance; possibly causing headaches or eye or lung

irritation. This is a normal and temporary occurrence.

The initial break-in operation should last two to three

hours with the burner at the highest setting. Provide

maximum ventilation by opening windows or doors to

allow odors to dissipate. Any odors remaining after this

initial break-in period will be slight and will disappear

with continued use.

21. Input ratings are shown in BTU per hour and are for

elevations up to 2,000 feet. For elevations above 2,000

feet, input ratings should be reduced 4 percent for each

1,000 feet above sea level. Refer to the National Fuel

Gas Code.

22. The appliance and its appliance main gas valve must

be disconnected from the gas supply piping system

during any pressure testing of that system at test

pressures in excess of

23. The appliance must be isolated from gas supply piping

system by closing its equipment shutoff valve during

any pressure testing of the gas supply piping system at

test pressures equal to or less than

24. Do not use this room heater if any part has been under

water. Immediately call a qualified service technician

to inspect the room heater and to replace any part of

the control system and any gas control which has been

under water.

25. Never burn solid fuels in a fireplace where a unvented

room heater is installed.

⁄

psig (3.5 kPa).

⁄

psig (3.5 kPa).

This appliance may be installed in an after-

market, permanently located, manufactured

(mobile) home, where not prohibited by local

codes.

This appliance is only for use with the type of

gas indicated on the rating plate. This appliance

is not convertible for use with other gases.