TP-Link TL-WR843N User Manual page 86

Chapter 5
• Enable SSID Broadcast
name (SSID).
• Enable WDS Bridging
fill in the parameters below.
• SSID (to be bridged)
Click Survey
want to connect to, and click
network's SSID and BSSID (MAC address) will be automatically filled into the
corresponding box.
• BSSID (to be bridged)
to connect to.
• WDS Mode - Select Auto,
• Key type - This option should be chosen according to the AP's security
configuration. It is recommended to select the same type as that of the AP.
• WEP Index - This option should be chosen if the key type is WEP (ASCII) or WEP
(HEX). It indicates the index of the WEP key.
• Auth type - This option should be chosen if the key type is WEP (ASCII) or WEP
(HEX). It indicates the authorization of the AP.
• Password - Enter the network password of the AP your router is connected to.
5. 5. 2. Wireless Security
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Wireless > Wireless
3. Configure the security settings of your wireless network and click Save.
- If enabled, the router will broadcast the wireless network
- If enabled, the router can bridge two or more WLANs. Please
- The SSID of the AP the router is going to connect to.
and the AP List page will appear. Find the SSID of the AP you
Connect
- The BSSID (MAC address) of the AP the router is going
WDS1 or WDS2. It is recommended to leave it to Auto.
Security.
Configure the Router in Standard Wireless Router Mode
in the corresponding row. The target
83