Panasonic AJ-SD93 Operating Instructions Manual page 41

Error messages (continued)
Priority Monitor display
E-01
(LOW RF)
E-02
(HIGH ERROR
Low
RATE)
Error messages
Monitor display
If condensation is detected, the error number flashes
and the unit transfers to eject mode. The drum rotates
after the cassette is ejected to eliminate the
condensation.
Once the unit is released from condensation status,
E-20
the error message display is cleared and the VTR is
DEW
able to be used.
• If condensation is detected in the eject mode, the
drum starts rotating as soon as it is detected.
• If condensation is detected when the cassette has
been inserted, the drum rotation is stopped, and
after the tape is ejected, the drum starts rotating.
The unit switches to eject mode and if the cassette
fails to move up within 6 seconds, this error number
flashes on the display.
E-29
Note:
FRONT LOAD
If the cassette does not move down inside the
MOTOR
machine even when 6 seconds have elapsed since
the cassette was inserted, the VTR is transferred to
the eject mode.
If the unloading operation is not completed within 6
seconds, this error number flashes on the display.
E-31
Note:
LOADING
When the loading operation is not completed within 6
MOTOR
seconds, the VTR is transferred to the eject
(unloading) mode.
E-35 If there is no response from the servo microcomputer
SERVO CONTROL for 1 second or more, this error number flashes on
ERROR the display.
If 10 seconds or more elapses and the servo
E-37
microcomputer has not followed orders issued by the
SERVO COMM
system control microcomputer, this error number
ERROR
flashes on the display.
If the take-up reel rotates without engaging for a
E-51
specific period of time during the start or end
FRONT LOAD
processing operation while loading is underway (half
ERROR
position), this error number flashes on the display.
Description
This appears when an envelope level
approximately one-third of the normal level
has been detected for more than one
second during playback or recording.
This appears when the error rate has
increased to the extent that correction or
interpolation was applied to either the video
or audio playback signals.
Description
– 41 –
Corrective action
Clean the video heads.
Clean the video heads.
Corrective action
Leave the power on and
wait.
Set the POWER switch
to OFF and then to ON
again.
Set the POWER switch
to OFF and then to ON
again.
Set the POWER switch
to OFF and then to ON
again.
Set the POWER switch
to OFF and then to ON
again.
Set the POWER switch
to OFF and then to ON
again.
VTR operation
O p e r a t i o n
continues.
O p e r a t i o n
continues.
VTR operation
EJECT
STOP
STOP
STOP
STOP
STOP