Rear Panel - Panasonic AG-TL950 Operating Instructions Manual

2 CONTROLS AND CONNECTORS
2-1 FRONT PANEL

2-3 Rear Panel

1
[AC IN] connector
Connect to an AC 120 V, 50 Hz/60 Hz socket using the
AC mains cable.
2
[SPARE] spare connector
This connector is not used now and thus has on
function.
3
[MIC] mic input connector
Connect a microphone with 3.6-mm dia. plug. When
signals are input from both the microphone connector
and the audio input connector, audio signals are mixed
and recorded.
4
[AUDIO IN] audio input connector (Phono)
Receives audio signals from a connected audio source.
5
[AUDIO OUT] audio output connector (Phono)
Outputs audio signals. No signal is output in the
Timelapse Recording/Playback mode.
6
[VIDEO IN] video input connector (BNC)
Receives composite video signals from a connected
camera or other video source.
• For composite video signal input, set the <INPUT>
menu switch in <VIDEO MODE> to LINE.
7
[VIDEO OUT] video output connector (BNC)
Outputs composite video signals. Even when the power
is not supplied to this unit, input signals (composite
video signals) from a camera can be output through this
connector (Operating mode-Off Video Throughout
function).
8
[S-VIDEO IN] S-VIDEO input terminal (4 pin)
Inputs separate Y/C signals.
• For separate Y/C signal input, set the <IN> menu
switch in <VIDEO MODE> to "S-VIDEO".
12
4 6
R S - 2 3 2 C
VIDEO
AUDIO
IN
SPARE MIC
OUT
3 5
2 7
8
S-VIDEO
COM CLOCK
CAM SW ALARM ALARM SERIES
OUT IN REC OUT RESET IN REC IN
ALARM TAPE WARNING CLOCK
COM
RESET END OUT OUT RESET OUT
CAM SW
9 10
9
[S-VIDEO OUT] S-VIDEO output terminal (4 pin)
Outputs separate Y/C signals.
0
Signal ground terminal
This ground terminal is not provided for safety purposes.
It is used to ground signals. Connect this terminal to
ground the signal between VCRs.
!
[CAM SW OUT] camera switching signal output
terminal
When a sequential switcher is connected, this terminal
outputs camera switching timing control signals. For
details on these signals, refer to page 56.
@
[COM] common ground terminal
Connect to the signal ground terminal of a connected
unit.
#
[ALARM IN] alarm signal input terminal
Receives signals to start alarm or sensor recording.
$
[ALARM RESET] alarm signal reset input terminal
Receives signals to cancel alarm recording.
* Alarm input data is not reset.
%
[ALARM REC OUT] alarm recording mode signal
output terminal
Outputs +12 V signals during alarm recording.
1
AC~IN
SERIES
REC OUT
COM
ALARM
ALARM
IN REC OUT
OUT
ALARM WARNING
TAPE
COM
RESET END OUT OUT
11 12 15
13 14 16 17 18
CLOCK SERIES
RESET IN
REC IN
SERIES
CLOCK
RESET OUT REC OUT
20 22
19 21