Panasonic AG-DVX100A Operating Manual page 16

Parts and their functions
COUNTER RESET button
This button is used to reset the counter value
on the counter display and the memory
counter value to zero.
It cannot reset the time code or user's bit.
COUNTER button
This button is used to select what data is to
be displayed on the counter display which is
in the viewfinder and on the LCD monitor.
Each time it is pressed, the data to be
displayed changes.
COUNTER:
The counter value is displayed.
M COUNTER:
The counter value in the memory stop
mode is displayed.
TC : The time code is displayed.
UB : The user's bit is displayed.
FR : The frame rate information (25P) when
shooting is to be performed in the
progressive mode is displayed.
Blank display :
No data is displayed.
Memory stop mode
The memory stop mode is established when the
display is switched to M COUNTER using the
COUNTER button.
1 Switch the display to M COUNTER, and press the
COUNTER RESET button
reset the counter value.
2 Proceed with playback or shooting.
3 Establish the VCR mode using the CAMERA/VCR
button.
4 When the tape is now rewound or fast forwarded, it
stops travelling automatically near where the counter
value was reset.
O If the counter value is reset at the OUT point during
audio dubbing, audio dubbing can be stopped in the
memory stop mode.
16 (E)
at any tape position to
MODE CHK button
When this button is pressed, the current
camera status setting can be checked in the
viewfinder and on the LCD monitor.
ZEBRA button
When this button is pressed in camera mode,
a zebra pattern or marker appears in the
viewfinder and on the LCD monitor, enabling
the brightness of the subject to be checked.
Each time it is pressed, the display changes
as shown below.
OFF
ZEBRA 2
Marker
The level of each zebra pattern can be set
using the ZEBRA DETECT 1 item and
ZEBRA DETECT 2 item on the setting menu
DISPLAY SETUP screen.
The zebra pattern which has been set is
displayed as a percentage for the prescribed
time (approx. 2 seconds).
Display of the marker can also be switched
ON/OFF with the MARKER item on this
screen. (See page 47)
Zebra pattern
Parts that may be whitened out due to overexposure
are displayed using a striped pattern.
OIS button
This button is used to set camera shake
compensation to ON or OFF.
compensation is ON,
viewfinder and on the LCD monitor.
Select ON or OFF to suit the shooting
conditions.
When shooting using a tripod, the OFF
setting is recommended.
Tripod mounting hole
ZEBRA 1
When the
appears in the