Chapter 3 Switch Configuration - Edimax GS-5008PL User Manual

Chapter 3 Switch Configuration

System
Management
Port
VLAN
Trunking
QoS
Broadcast Storm Control
Loop Detect/Prevent
IGMP Snooping
PoE
Password
Logout
The PoE smart switch software provides rich layer 2 functionality for
switches in your networks. This chapter describes how to use the
web-based management interface (Web UI) to configure the switch's
features.
The left column shows the configuration menu. The top row shows
the switch's current link status. Green squares indicate the port link is
up, while black squares indicate the port link is down. Below the
switch panel, you can find a common toolbar to provide useful
functions. The rest of the screen area displays the configuration
settings.
This link takes you to a screen where you can configure device name and ip.
This link takes you to screens where you can perform firmware and
configuration file maintenance as well as reset and reboot the system.
This link takes you to a screen where you can check Link Status, TX/RX
counter, Loop Status and Loop Reset.
This link takes you to screens where you can configure port-based or
802.1Q VLAN.
This link takes you to screen where you can logically aggregate physical
links to form one logical, higher-bandwidth link.
This link takes you to screen where you can enable Port-Based QoS or
IEEE 802.1p QoS
This link takes you to screen where you can set up broadcast rate limit on
every port.
This link takes you to a screen where you can check Loop Detection and
Loop Prevention
This link takes you to screens where you can configure IGMP Snooping.
This link takes you to screens where you can configure PoE.
This link takes you to screens where you can change the system login
password.
Logout system.
8