Setting Up The Unit Before Use - Panasonic KX-TG9391 Operating Instructions Manual

Preparation
L If you want to use the handset immediately,
charge the batteries for at least 15 minutes.
L Clean the charge contacts of the handset and
charger with a soft and dry cloth once a month.
Clean more often if the unit is exposed to
grease, dust, or high humidity.
Battery level
Battery icon
1
2
3
4
Note:
L The batteries need to be charged if the handset
beeps while you are engaged in a call or
operating the answering system remotely.
Panasonic Ni-MH battery performance
(supplied batteries)
Operation
In continuous use
Not in use (standby)
Note:
L Actual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
L Even after the handset is fully charged, the
handset can be left on the charger without any ill
effect on the batteries.
L The battery level may not be displayed correctly
after you replace the batteries. In this case,
place the handset on the charger and let it
charge for at least 7 hours.
16
Battery level
High
Medium
Low
L When flashing: Needs
to be charged.
Empty
Operating time
12 hours max.
6 days max.
For assistance, please visit http://www.panasonic.com/help
Setting up the unit before
use
Display language
You can select either "English" or "Español"
as the display language. The default setting is
"English".
: Base unit / Y Handset
1
{MENU} i {#}{1}{1}{0}
2
{V}/{^}: Select the desired setting.
3
Press the middle soft key to save.
4
Proceed with the operation for your unit.
Base unit: {■} (EXIT)
Handset: {OFF}
Voice guidance language
You can select either "English" or "Español"
as the voice guidance language of the answering
system. The default setting is "English".
Program this setting using either the base unit or
one of the handsets.
: Base unit / Y Handset
1
{MENU} i {#}{1}{1}{2}
2
{V}/{^}: Select the desired setting.
3
{SAVE}
4
Proceed with the operation for your unit.
Base unit: {■} (EXIT)
Handset: {OFF}
Dialing mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is "Tone".
"Tone": For tone dial service.
"Pulse": For rotary/pulse dial service.
Program this setting using either the base unit or
one of the handsets.
: Base unit / Y Handset
1
{MENU} i {#}{1}{2}{0}
2
{V}/{^}: Select the desired setting.
3
{SAVE}