Troubleshooting - Panasonic KX-TG2224F Operating Instructions Manual

Troubleshooting

Cordless Telephone
Problem
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or base
unit does not ring.
The handset display is
blank.
You cannot program
function items.
While programming or
searching, the unit starts to
ring and stops the
program/search.
You cannot make a call
with the handset.
You cannot redial.
For assistance, please call: 1-800-211-PANA(7262)
Cause & Remedy
• You are too far from the base unit. Walk closer
and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
• Move the handset and the base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 23, 37).
• The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 17).
• When the handset is on the base unit, the
handset does not ring. Only the base unit rings
when receiving a call.
• Charge the battery fully (p. 8).
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• A call is coming in. To answer the call, press
[ ] or [ ]. Start again from the beginning after
hanging up.
• Your handset is in remote operation mode
(p. 42). Exit by pressing [OFF].
• If the last number dialed was more than 32 digits
long, the number will not be redialed correctly.
51