Troubleshooting; Before Calling Service - Panasonic DP-1810F Operating Instructions Manual

Troubleshooting

Before Calling Service

Unit Does Not Operate
Does the display light?
Does the Energy Saver key flash (or light)
and displays are turned OFF? (See page
23)
Does any of the U## codes and messages
appear on the display?
(U01, U07, U13, U14, U20 and U21) (See
page 48)
Does the add paper indicator and message
appear on the display? (J)
Does the paper misfeed indicator and
message appear on the display? (I)
Does E#-## indicator and message appear
on the display?
When the Add Toner Warning Indicator begins to flash
one. After this warning is activated, machine operation will begin with the Toner Charging Mode
(approximately 3 minutes to complete) each time the power switch is turned Off then On or if the
Front/Right Cover is opened and then closed.
Note:
Machine operation and displays are as follows:
1. When turning the power switch to On or opening and then closing the Front/Right Cover, the
machine starts to warm-up and the LCD displays:
46
Check
(No)
(No)
(No)
∗
(No)
(No)
∗
When the warning indicator starts flashing, a 300-sheet count-down counter is activated,
and upon reaching 0 the machine will stop operating. The 300-sheet counter is based on
6% fill, depending on the density some pages may print Blank.
PLEASE WAIT...
Action
Check if the Power Switch is turned On and
that the power cord is connected into the
outlet.
(Yes)
Press Energy Saver key on the Control
Panel.
(Yes)
Perform actions in accordance with each
message.
(Yes)
Add paper. (See page 38)
(Yes)
Remove the misfed paper. (See page 41)
(Yes)
Turn the copier Off, then On. If the Error
Code does not clear, call for service.
(Yes)
∗
or is lit, replace the toner bottle with a new