Machine Maintenance Procedures
Introduction
This chapter contains general information about the computer, a list of tools needed to do the
required maintenance and step by step procedures on how to remove and install components
from the computer.
General Information
The product previews seen in the following procedures may not represent the final product
color or configuration. Cable paths and positioning may also differ from the actual model.
During the removal and installation of components, make sure all available cable channels
and clips are used and that the cables are installed in the same position.
All prerequisites must be completed prior to starting maintenance.
Recommended Equipment
The following equipment are recommended to do the following maintenance procedures:
Wrist grounding strap and conductive mat
Flat screwdriver
Philips screwdriver
Plastic tweezers
Flat plastic pry
Table 3-1. Screw List
Size
M2.5*6.0
M2.0*3.0
M2.5*3.0 Ni
M2.5*4.0
M2.0*2.0
M3.0*3.0 Ni
Machine Maintenance Procedures
Quantity
18
12
2
14
1
4
Acer Part No.
86.ARE07.001
86.ARE07.002
86.R6Z07.001
86.PSR07.001
86.W4107.002
86.N1407.007
0
0
0
3-5