Xerox 700 Digital Color Press User Manual page 166

Problem Solving
Code
8-32
Downloaded From ManualsPrinter.com Manuals
Cause/Remedy
Cause: In [Scan to FTP/SMB], or [Job Template], the forwarding destination or job template
save location could not be accessed.
Remedy: Check whether you can access the specified forwarding destination.
Cause: Specified job history could not be acquired, when printing [Job Counter Report]
Remedy: Specified job history does not exist.
Cause: The hard disk has run out free space.
Remedy: Either remove unnecessary data from the hard disk to increase free disk space, or
initialize the hard disk.
Cause: An error occurred when reading data stored in a media (such as a card reader for a
digital camera).
Remedy: Check the data stored in the media with a computer.
Cause: During an inspection or maintenance request, a transmission error occurred, and
your Xerox Customer Support Center could not be contacted.
Remedy: Check that the phone lines are connected, and try sending an inspection or
maintenance request again after a short time. If the error persists, contact your Xerox
Customer Support Center.
Cause: A feature (one of paper size, tray, output tray, or 2 sided printing) that is
incompatible with the specified paper quality has been specified.
Remedy: Check the print data.
Cause: An illegal print parameter combination was set. For example, a non-standard size
was specified and Tray Selection was set to Auto.
Remedy: Check the print data. In the above case, select Tray 5 (Bypass).
Cause: The Staple Waste Container is full or near full.
Remedy: Remove the Staple Waste Container and reinstall a new one.
Cause: The Staple Waste Container is not attached.
Remedy: Check that the Staple Waste Container is installed in the finisher and inserted
correctly.
Xerox 700 Digital Color Press
User Guide