Panasonic EY4550 Service Manual page 7

Procedure 1A → 1B → 1C → 1D → 1E
Ref. No. 1E
Procedure 1A → 1B → 1C → 1D → 1E → 1F Removal of control PCB.
Ref. No. 1F
Removal of the switch.
1. Pull out the lead wires from the pressure terminal.
(for reassembly)
1. Connect the motor lead wires (black and red) with the heat contraction
tube.
NOTE:
Make sure to attach the adhesive tape to fix the lead wires.
NOTE:
Make sure to place the switch without pinching the lead wires over
the rib of housing.
(Removal)
Pull out the connector from the module assembly.
NOTE:
Make sure to hold the connector at the bottom area.
(Assembly)
1. Apply the permalub grease around the tactswitch and connectors.
NOTE:
Make sure to apply the grease to keep IP56.
2. Insert the connector firmly.
7