Xerox Versant 80 Press Installation Manual page 26

GBC AdvancedPunch Pro
GBC
 GBC AdvancedPunch Pro does not work in conjunction with C/Z-fold or Standard Finisher punch, staple, or booklet
AdvancedPunch
making
Pro Limitations
 Hole punch position from edge of paper is user adjustable using the AdvancedPunch Pro LCD User Interface
 Opening the door of the GBC AdvancedPunch Pro while the machine is running will cause the machine to jam and shut
down
 Gloss coated media may not run as reliably as uncoated paper. Typically, coated papers and high area coverage exhibit
increased variability in paper handling due to lower coefficients of friction, resulting in a broader distribution of punch
registration and elevated jam rates
 Stacking may be misaligned on jobs containing tab stock; these jobs will require additional jogging before final finishing
 Due to the nature of punching holes, each punched sheet is slightly deformed, and when stacked, the edge with the
holes will have an increased height compared to the non-punched edge.
-
-
GBC AdvancedPunch Pro
Punch Dies
The GBC AdvancedPunch Pro is capable of punching a variety of hole-punch patterns by simply changing the punch die. Punch dies can be
changed in seconds without tools. The punch dies currently available are listed below. Each die set has a 90 day warranty from date of
purchase. Punch dies are ordered using the Supplies ordering process.
Punch die life will be maximized if lightly oiled every 100K punch cycles (approximately every 2 months) with light machine
oil such as 3-in-1 Oil. Small deposits of oil will be observed around the perimeter of the punched holes until the excess oil is
absorbed (usually within 20 sheets).
Customer Expectation & Installation Guide
Reduced stack quality may be experienced due to variability in the punch hole formation
When sending output to the stack tray of the High Capacity Stacker, if this stack height difference exceeds
one inch, the machine will shut down and alert the operator to unload the stacker tray. This is done to prevent
a jam and will result in a reduction of stack capacity depending on the die being used
Versant 80 Press