Disassembly And Replacement - Toshiba e-STUDIO350 Service Manual

13.7 Disassembly and Replacement

[A] Fuser unit
(1) Take off the IH terminal cover (
2.5.1 [L]).
(2) Open the jam access cover and fuser unit
cover. Disconnect 1 connector with lock, 2
faston terminals and 2 joint connectors.
(3) Release the harness from 1 harness clamp.
(4) Close the fuser unit cover.
(5) Remove 2 screws and take off the fuser unit.
Notes:
1. Make sure to hold the plastic part of the
faston terminals when disconnecting them.
2. Be careful not to connect each terminal to
the wrong position.
[B] Fuser unit cooling fan
13
(1) Take off the fuser unit (
(2) Take off the fuser unit cover by pushing
it to the right.
(3) Remove 2 screws and take off the fuser unit
cooling fan unit.
e-STUDIO350/450 FUSER UNIT / PAPER EXIT SECTION
Chapter
Chapter 13.7 [A]).
13 - 16
Harness clamp
Fig. 13-701
Screw
Fig. 13-702
Fig. 13-703
Fig. 13-704
November 2003 © TOSHIBA TEC