Table of Contents
Advertisement
ELECTRONIC 0
.
Your range features an easy-to-use electronic oven control.
Not only does this control operate all timed baking and
cleaning functions, it also controls the oven thermostat to
give you precisely controlled baking and broiling.
Control Buttons
SET/CANCEL button - use to set clock or cancel
programmed functions and turn oven off. Can be used to
cancel mistakes or reprogram control,
MINUTE TIMER button - use to time rangetop cooking,
oven baking, or other various kitchen activities.
CLOCK button - use to set the time of day.
COOK TIME button - use to set timed baking functions.
CLEAN button - use to set oven for self-clean cycle. See
page I7 for self-cleaning instructions.
STOP TIME button - use to set delayed bake and self-
clean operations.
BROIL button - use to program broil feature. See page 13
for broiling instructions.
BAKE TEMP button - use to set any of the bake
operations.
temperatures.
Each time these buttons are pressed, you will hear a
confirmation tone, if this feature has been selected. This
confirmation tone is optional and can be deactivated, if
desired.
To deactivate the confirmation tone:
1. Push and hold the SET/CANCEL button. The button will
beep once initially and then beep again after about three
seconds. Release button. The confirmation tone is now
cancelled.
To reactivate the confirmation tone, push and hold SET/
2.
CANCEL button until you hear one beep. The control
buttons will now sound the tone each time any are
pressed.
Display Features
S E '
The words and numbers in the control's display will light
to indicate which functions have been programmed.
The "ON" indicator will light up in the display when the
bake and/or broil programs are selected.
The "ON" indicator will light up in the display when the
bake and/or broil programs are active.
"BAKE,"
the display will tell you which mode has been selected.
number of hours.
Signal Tones
End of Cycle Tone - after a timed oven operation is
finished, the oven will sound three long beeps. When the
Timer feature is used, it will sound three long beeps and
then it will beep once every ten seconds until the TIMER
button is pushed.
Service Tones - the oven control will sound a series of
short, rapid beeps and the display will show a diagnostic
service code if there is a problem with the electronic oven
control. See page 22 for further instructions.
The oven control will also beep if you delay too long
between programming steps.
"BROIL" and "CLEAN" on the right hand side of
up
Advertisement
Table of Contents
